Serial Enabled 16x2 LCD - Red on Black 5V
This is the latest evolution of our serial LCD.
Included on a single board is a 16x2 LCD and an embedded circuit based around a PIC 16F88.
The on-board PIC takes a TTL serial input and prints the characters it receives onto the LCD.
The installed firmware also allows for a number of special commands so
you can clear the screen, adjust the backlight brightness, turn the display on/off, and more.
Communication with SerLCD requires 5V TTL serial at a default baud rate of 9600bps (8-N-1).
You can adjust the baud to any standard rate between 2400 and 38400bps.
The power (VDD), ground (GND) and RX pins are all broken out to both a 0.1" pitch header as well as a 3-pin JST connector.
SerLCD has the ability to dim the backlight to conserve power if needed.
There is also a potentiometer on the back of the display to adjust the contrast.
This LCD makes for a great gift, because it can be used for so many different projects!
For more gift ideas check out the SparkFun Gift Guide!
מאפיינים:
- Embedded PIC 16F88 utilizes onboard UART for greater communication accuracy
- Adjustable baud rates of 2400, 4800, 9600 (default), 14400, 19200 and 38400
-
Operational Backspace
- Greater processing speed at 10MHz
- Incoming buffer stores up to 80 characters
- Backlight transistor can handle up to 1A
- Pulse width modulation of backlight allows direct control of backlight brightness and current consumption
- All surface mount design allows a backpack that is half the size of the original
- Faster boot-up time
- Boot-up display can be turned on/off via firmware
- User definable splash screen
מידות:
- PCB: 103x36mm
- LCD: 71.4x26.4mm
תיעוד: