FT200XD USB to I2C Converter Module
The UMFT200XDisa breakout board that converts USBFull-SpeedtoI2C.TheUSB-I2Cmoduleprovidesa complete interface between yourPCand theI2Cbus.Themoduleisself-poweredfrom theUSB cable.ThemoduleisanI2Cmaster only, not aslave.USB toI2CProfessionalisa general-purposeI2CandSPIinterface tool thatallowsausertocommunicatewith anyI2CorSPIslave devices.USB-to-I2Cincludesthe USB-based hardware andWindowssoftwareanddriverthat is compatible with 64-bit versions ofXP, Vista,Windows7,Windows8, andWindows10.
Specifications:
Up to 3.4MHz, high-speed mode, I2C supported
Entire USB protocol handled on the chip, no USB specific firmware programming required
Fully integrated 2048 byte multi-time-programmable(MTP) memory storing device descriptors and CBUS I/O configuration
Fully integrated clock generation with no external crystal required plus optional clock output selection enabling a glue-less interface to external MCU or FPGA
512 byte receive buffer and 512 bytes transmit
USB Power Configurations supports bus-powered, self-powered and bus-powered with power switching
Integrated +3.3V level converter for USB I/O
True 3.3VCMOS drive output and TTL input, Operates down to 1V8with external pull-ups, tolerant of 5V input
Configurable I/O pin output drive strength, 4mA(min) and 16mA(max)
Integrated power-on-reset circuit
Fully integrated AVCC supply filtering - no external filtering required
Internal 3V3/1V8 LDO regulators
Features:
Chip:FT200XD
Operating Voltage: 5V
Interface: USB, I2C
Pin Number: 6 Pins