Carbon Monoxide Gas Sensor MQ-7
This Carbon Monoxide (CO) gas sensor detects the concentrations of CO in the air and ouputs its reading as an analog voltage. The sensor can measure concentrations of 10 to 10,000ppm.The sensor can operate at temperatures from -10 to 50°C and consumes less than 150mA at 5V. Please read the MQ7 datasheet (185k pdf) for more information about the sensor.
Connections
Connecting five volts across the heating (H) pins keeps the sensor hot enough to function correctly. Connecting five volts at either the A or B pins causes the sensor to emit an analog voltage on the other pins. A resistive load between the output pins and ground sets the sensitivity of the detector. The resistive load should be calibrated for your particular application using the equations in the datasheet, but a good starting value for the resistor is 10kΩ.
We offer two breakout boards that make it easier to interface with these sensors: a Pololu carrier board and a SparkFun carrier board. The Pololu version is shown below.
File downloads
- Carbon Monoxide gas sensor MQ-7 datasheet (185k pdf)