Mini Metal Gearmotor 26:1 438 RPM
Mini Metal Gearmotor 26:1 438 RPM
This motor has a 0.275" (7 mm) D-shaped metal output shaft that matches the Pololu wheel 42x19mm and 32x7mm.
The face plate has two mounting holes threaded for M2 screws.
These motors are intended for use at 6V. In general, these kinds of motors can run at voltages above and below this nominal voltage, so they should comfortably operate in the 3 – 9 V range.
Lower voltages might not be practical, and higher voltages could start negatively affecting the life of the motor.
מאפיינים:
- 25:1 gear ratio
- 438rpm @ 6V
- 44mA @ 6V
- 6 oz inches torque @ 6V
תיעוד:
כתוב בקורת
שם פרטי
ביקורת : הערה ללא תרגום מ HTML!
דירוג רע טוב
הכנס את הקוד התיבה

ביקורת : הערה ללא תרגום מ HTML!
דירוג רע טוב
הכנס את הקוד התיבה