Chipquik SMD Removal Kit

Chipquik SMD Removal Kit

The CHIP QUIK® SMD Removal Kit is a quick and inexpensive way to remove SMD
components from a PCB without a hot air station using only your soldering iron.
The heart of the kit is a length of Chipquik low temperature alloy.
This alloy is like a solder that melts at temperatures well below that of normal solder (136°F)
and stays liquid long enough to melt the existing solder, allowing you time to carefully remove the component.

Simply apply a liberal amount of the included flux to the pins of the
chip that you want to remove, then use a soldering iron with a flat-edge tip to heat the pins
while applying the low temperature alloy. The alloy will remain liquid for a few seconds while you
coat all of the connections, once you've coated the pins you should be able to lift the
chip free using tweezers or a hemostat. Clean the pads thoroughly and apply fresh
solder and you're ready to solder a new part in place.
 

Note: Solder wick comes in handy with this kit, so it might be a good idea to have some on hand.
Check below if you don't already have some.

הקיט כולל:

• 1 Tube of CHIP QUIK® Rework Paste Flux
• 2.5 ft. of CHIP QUIK® Low Temperature Alloy (Removes 8-10 Chips)
• Alcohol Prep Pads

תיעוד:

• Rework Guide