X9C104P DIP-8  Digital Potentiometer

The X9C104 are Intersils’ digitally controlled (XDCP) potentiometers. The device consists of a resistor array, wiper switches, a control section, and non-volatile memory. The wiper position is controlled by a three-wire interface. The potentiometer is implemented by a resistor array composed of 99 resistive elements and a wiper switching network. Between each element and at either end are tap points accessible to the wiper terminal. The position of the wiper can be stored in non-volatile memory and then be recalled upon a subsequent power-up operation. The

device can be used as a three-terminal potentiometer or as a two-terminal variable resistor in a wide variety of applications ranging from control to signal processing to parameter adjustment. 

Specification

• Solid-State Potentiometer

• Three-Wire Serial Interface
• 100 Wiper Tap Points
  • Wiper Position Stored in Non-volatile Memory and Recalled on Power-up
• 99 Resistive Elements
  • Temperature Compensated
  • End-to-End Resistance, ±20%
  • Terminal Voltages, ±5V
• Low Power CMOS
  • VCC = 5V
  • Active Current, 3mA max.
  • Standby Current, 750µA max.
• High Reliability
  • Endurance, 100,000 Data Changes per Bit
  • Register Data Retention, 100 years
• X9C104 = 100kΩ
• Packages
  • 8 Ld PDIP
• Pb-Free Available (RoHS Compliant)

Package includes 1Pc X9C104P Digital Potentiometer 100KOhm Single 8-Pin PDIP

Arduino lib