סל הקניות
0 פריטים
 
             קטגוריות
 

DRV8835 Dual Motor Driver Carrier

DRV8835 Dual Motor Driver Carrier
לחץ להגדיל
מחיר ₪45
זמינות המוצר במלאי
דגם 2135
דירוג ממוצע ללא דירוג

Share |


כמות הוסף לסל

DRV8835 Dual Motor Driver Carrier
 

Texas Instruments’ DRV8835 is a tiny dual H-bridge motor driver IC that can be used for bidirectional control of two brushed DC motors at 0 V to 11 V. It can supply up to about 1.2 A per channel continuously and can tolerate peak currents up to 1.5 A per channel for a few seconds, making it an ideal driver for small motors that run on relatively low voltages. The DRV8835 is a great IC, but its small, leadless package makes it difficult for the typical student or hobbyist to use; our breakout board gives this driver the form factor of a 14-pin DIP package, which makes it easy to use with standard solderless breadboards and 0.1″ perfboards. Since this board is a carrier for the DRV8835, we recommend careful reading of the DRV8835 datasheet (1MB pdf). The board ships populated with SMD components, including the DRV8835, and adds a FET for reverse battery protection.

Alternative driver options

This board is very similar to our DRV8833 dual motor driver carrier in operating voltage range and continuous current rating, but the DRV8835 has a lower minimum operating voltage, offers an extra control interface mode, and is 0.1″ smaller in each dimension. The DRV8833 has a higher peak current rating (2 A per channel vs 1.5 A), optional built-in current-limiting, and no need for externally supplied logic voltage.

For a smaller, lower-cost, single-channel alternative to this driver, please consider our DRV8838 carrier. The DRV8838 has the same operating voltage range as the DRV8835 and very similar current capabilities, and it uses the same PHASE/ENABLE control interface.

 

 

 

Dimensions

Size: 0.4″ × 0.7″1
Weight: 0.5 g1

General specifications

Motor driver: DRV8835
Motor channels: 2
Minimum operating voltage: 0 V
Maximum operating voltage: 11 V
Continuous output current per channel: 1.2 A2
Peak output current per channel: 1.5 A
Continuous paralleled output current: 2.4 A2
Maximum PWM frequency: 250 kHz
Minimum logic voltage: 2 V
Maximum logic voltage: 7 V
Reverse voltage protection?: Y


 

כתוב בקורת
שם פרטי


ביקורת : הערה ללא תרגום מ HTML!

דירוג רע            טוב

הכנס את הקוד התיבה

DRV8835 Dual Motor Driver Carrier
לחץ להגדיל
DRV8835 Dual Motor Driver Carrier
לחץ להגדיל
DRV8835 Dual Motor Driver Carrier
לחץ להגדיל
DRV8835 Dual Motor Driver Carrier
לחץ להגדיל
DRV8835 Dual Motor Driver Carrier
לחץ להגדיל
DRV8835 Dual Motor Driver Carrier
לחץ להגדיל
DRV8835 Dual Motor Driver Carrier
לחץ להגדיל